Analysis and solutions to various problems of Polyethylene PE Film

1. The problem is that the polyethylene pe film does not adhere firmly

This problem is likely to be that the pressure-sensitive adhesive of the polyethylene pe film is not sufficiently viscous, or the pressure is not up to the standard, and the adhesive surface is not clean enough, and so on. According to these conditions, the higher method is to replace the pressure-sensitive adhesive or film pressure to avoid similar problems.　

2. The problem is that both ends of the polyethylene pe film are lifted up after use

Generally, it will only appear after the high temperature is encountered when the degree of stretching of the polyethylene pe film is too large. It can be seen that the environmental temperature has a very large impact on the quality of the polyethylene pe film.

3.polyethylene pe film degumming problem

This is a very common problem, that is when the protective film is torn off from the surface of the profile, the adhesive represented by the protective film remains on the profile product.

If the user has this kind of problem, he can use a clean cloth dipped in a little alcohol to repeatedly wipe the remaining sensitive adhesive until the sensitive adhesive is wiped clean. But don't use too much force, so as not to affect the surface of the material.

4. The problem of difficult peeling of polyethylene pe film

There are two reasons for this problem. On the one hand, the sensitive adhesive used may not be a special sensitive adhesive for protective film. On the other hand, the material used in the protective film master tape is too soft to withstand the pulling force during peeling. Basically, either replace the pressure-sensitive adhesive or replace the material of the protective film master tape.